MHEDA Connection
facebook
May 1, 2016
Archive | MHEDA Home | Executive Dialogue | MHEDA Journal | Contact Us

Solving a Storage Crisis

Print Print this Article | Send to Colleague

Gene Messer Toyota was facing a storage crisis. The Lubbock, Texas-based dealership had redesigned its parts department and was looking to increase its part storage in the counter area. The problem was, the parts department didn’t have the storage it needed to handle the increased quantity. Out of ideas, Parts Manager Mark Schroeder contacted Western Storage and Handling President Harry Neumann for help.
 
Neumann contacted Borroughs Corporation to help find the ideal storage unit for the job. After discussing with Schroeder, Harry recommended installing red High-Density Drawers from Borroughs into the shelving.
 
"The drawers were just the thing to free up some of the existing closed-shelving units and also offered new storage in the back room," says Neumann. "The new storage was more accessible to the parts and service employees and by putting the parts closer to the counter, it also reduced the pick time for each pick. This not only made the operation more organized but also more efficient and gave employees more room to move around in the back room of the parts area for faster customer service."
 
Harry recommended using units that measured 87 in. high, 48 in. wide and 24 in. deep, utilizing the bottom 48 in. of each unit for drawers while leaving the top portion for open shelf storage. Each unit had two 9 in. drawers and five 6 in. drawers.
 
"The drawers slide out smoothly on ball-bearings to view and access the entire contents of the drawer and can support up to 400 pounds of an evenly distributed load," Neumann says. "Those features really sold Gene Messer on using the Borroughs HD Drawers."
 
The dealership actually purchased the units before the remodel was complete, which left the layout up in the air. Ultimately, the company decided to purchase six shelving units, which allowed them to eliminate 24 sections of shelving in the back room. Four of the units were placed in the middle of the newly renovated parts department, side-by-side and back-to-back, while the last two units were placed side-by-side on the wall.
 
"This layout provided access to all the parts in the drawers and still allowed employees to move carts through the area and have customers walk through unimpeded," says Neumann. "The employees are very happy with the changes and the dealership is actually anxious to put more of these units to work in other areas of the dealership."
 
Installation on the project took only one day and was completed by Harry and Daniel Neumann. In the end, Gene Messer has a more organized and more streamlined parts department.
 
Distributor: Western Storage and Handling
Supplier: Borroughs Corporation

Read more Sales Success Stories here.
 

Share Share on Facebook Share on Twitter Share on LinkedIn

 
Material Handling Equipment Distributors Association
201 US Hwy 45, Vernon Hills, IL 60061-2398
Phone: 847.680.3500 FAX: 847.362.6989
connect@mheda.org
www.mheda.org
Submit News

Subscribe

©2019 MHEDA. All rights reserved,
The Contents of this publication may not be reproduced by any means, in whole or in part, without prior written consent of the publisher.